Toyota Sienna Service Manual: Name plate

Installation

1. INSTALL REAR BUMPER COVER Install the rear bumper cover with the 2 screws and 8 clips. ...

Rear spoiler

COMPONENTS ...

Other materials:

Entire Combination Meter does not Operate
DESCRIPTION This is the power source circuit to operate the combination meter assembly. WIRING DIAGRAM INSPECTION PROCEDURE 1 INSPECT COMBINATION METER ASSEMBLY Disconnect the C10 connector. Measure the resistance according to the value(s) in the table below. Standard resistan ...

Diagnostic trouble code chart
HINT: If a malfunction code is displayed during the DTC check, check the circuit indicated by the DTC. For details of each code, turn to the page for the respective "DTC Code" in the DTC chart. DTC chart of ABS: DTC chart of VSC: ...

Auto Up Operation does not Fully Close Power Window (Jam Protection Function is Activated)
DESCRIPTION If AUTO UP operation does not fully close the power window, the following conditions may be the cause.  The reset of the power window motor has not been completed, resulting in activation of the jam protection function.  The memory of the power window switch misse ...