Toyota Sienna Service Manual: Rear spoiler

Name plate

REPLACEMENT 1. INSTALL NAME PLATE ...

Removal

1. REMOVE BACK DOOR CENTER GARNISH Using a clip remover, disengage the 5 clips to remove the back door center garnish. 2. REMOVE REAR SPOILER Disconnect the center stop light connecto ...

Other materials:

Installation
1. INSTALL REAR NO. 2 SEAT ASSEMBLY  Lock the seat leg rear to the floor striker.  Lock the seat leg front to the floor striker.  Install the rear No. 2 seat assembly with the 6 bolts. Torque: 19 N*m (194 kgf*cm, 14 ft.*lbf) NOTICE: Tighten the bolts in the order sho ...

Front Fog Light Circuit
DESCRIPTION The Multiplex network body ECU controls FOG relay when signal is received from headlight dimmer switch assembly. WIRING DIAGRAM INSPECTION PROCEDURE 1 PERFORM ACTIVE TEST BY INTELLIGENT TESTER Connect the intelligent tester to DLC3. Turn the ignition switch ON and push t ...

Sound Signal Circuit between Radio and Navigation Assembly and Television Display Assembly
DESCRIPTION The television display assembly sends an RSE sound signal to the radio and navigation assembly through this circuit. The sound signal that has been sent is amplified by the stereo component amplifier, and then is sent to the speakers. If there is an open or short in the circuit ...