Toyota RAV4 manuals

Toyota Sienna Service Manual: Parking brake system

Parking brake
...

Problem symptoms table
Use the table below to help you find the cause of the problem. The numbers indicate the likelihood of the cause in the descending order. Check each part in the order shown. Replace these parts ...

Other materials:

Radio and Navigation Assembly Communication Error
INSPECTION PROCEDURE 1 IDENTIFY THE COMPONENT SHOWN BY THE SUB-CODE Enter the diagnostic mode.  Press the "LAN Mon" switch to change to "LAN Monitor" mode.  Identify the component shown by the sub-code. HINT:  "110 (multi-display)" i ...

If the battery is discharged
The following procedures may be used to start the engine if the vehicle’s battery is discharged. You can call your Toyota dealer or qualified repair shop. If you have a set of jumper (or booster) cables and a second vehicle with a 12-volt battery, you can jump start your vehicle by following ...

DTC check / clear
1. DTC CHECK (USING SST CHECK WIRE)  Check the DTCs (Present trouble code).  Turn the ignition switch ON, and wait for approximately 60 seconds.  Using SST, connect terminals TC and CG of the DLC3. SST 09843-18040 NOTICE: Connect the terminals to the correct p ...

© 2011-2026 Copyright www.tsienna.net