Toyota Sienna Service Manual: Problem symptoms table
HINT: Proceed to the troubleshooting for each circuit in the table below.
AIRBAG SYSTEM
|
Symptom |
Suspected Area |
| The SRS warning light goes off after the primary check, but then comes on. | SRS Warning Light Remains ON |
| When the ignition switch is turned to the ON position, the SRS warning light sometimes remains on even after approximately 6 seconds. | SRS Warning Light Remains ON |
| The SRS warning light always comes on even when no DTC is output. | SRS Warning Light Remains ON |
| When the ignition switch is turned to the ON position, the SRS warning light does not come on. | SRS Warning Light does not Come ON |
| Although the SRS warning light operates normally, a DTC or a normal system code is not displayed. | Diagnosis Circuit |
| Although terminals TC and CG are not connected, a DTC or normal system code is displayed. | Diagnosis Circuit |
How to proceed with
troubleshooting
HINT:
*: Use the intelligent tester.
1 VEHICLE BROUGHT TO WORKSHOP
2 CUSTOMER PROBLEM ANALYSIS
(a) Confirm problem symptoms
3 CHECK MULTIPLEX COMMUNICATION SYSTEM*
Check if the multi ...
Terminals of ECU
1. CENTER AIRBAG SENSOR ASSEMBLY (w/ Side
Airbag)
2. CENTER AIRBAG SENSOR ASSEMBLY (w/o Side
Airbag)
...
Other materials:
Short to GND in Front Pretensioner Squib RH
Circuit
DTC B0132/61 Short to GND in Front Pretensioner Squib RH
Circuit
DESCRIPTION
The front pretensioner squib RH circuit consists of the center airbag sensor
assembly and the front seat
outer belt assembly RH.
This circuit instructs the SRS to deploy when deployment conditions are met.
DTC B ...
Short to B+ in Rear Curtain Shield Squib RH
Circuit
DTC B1633/82 Short to B+ in Rear Curtain Shield Squib RH
Circuit
DESCRIPTION
The rear curtain shield squib RH circuit consists of the center airbag sensor
assembly and the curtain
shield airbag assembly RH.
The circuit instructs the SRS to deploy when deployment conditions are met.
DTC B ...
No. 2 Ultrasonic sensor
COMPONENTS
REMOVAL
1. REMOVE REAR BUMPER COVER (2)
2. REMOVE NO. 1 ULTRASONIC SENSOR RETAINER
Remove the No. 1 ultrasonic sensor retainer as
shown in the illustration
3. REMOVE NO. 2 ULTRASONIC SENSOR
Disconnect the connector and remove the No. 2
ultrasonic ...
