Toyota Sienna Service Manual: Rear bumper

Installation

1. INSTALL FRONT BUMPER ASSEMBLY Push the front bumper onto the front of the vehicle and engage the claws on the left and right sides of the front bumper to install it as shown in the il ...

Removal

1. REMOVE REAR BUMPER COVER Put protective tape under the quarter panel. Partially the fender liner. HINT: Do not remove the fender liner completely but partially so that the bumper co ...

Other materials:

Installation
1. INSTALL FRONT BUMPER ASSEMBLY Push the front bumper onto the front of the vehicle and engage the claws on the left and right sides of the front bumper to install it as shown in the illustration. HINT: Apply protective tape to the bottom part of the front fender to prevent i ...

Open in Side Squib LH Circuit
DTC B0116/48 Open in Side Squib LH Circuit DESCRIPTION The side squib LH circuit consists of the center airbag sensor assembly and the front seat side assembly LH. This circuit instructs the SRS to deploy when deployment conditions are met. DTC B0116/48 is recorded when an open circuit is ...

Parts location
SYSTEM DIAGRAM ...