Toyota Sienna 2010-2026 Owners Manual: Removing the second seats
Removing the second outside seats (Tip-up seats)
- Pull the armrests up.
Pull the seatback adjustment lever and fold down the seatback.
The cushion will tip up.
- Slide the seat forward to a lock position.
- Pull the release lever under the cushion and simultaneously lift the seat to remove.
Removing the second seats (Ottoman seats)
- Pull the armrests up.
Pull the seatback adjustment lever and fold down the seatback.
- Slide the seat to a forward lock position.
- Pull the release lever behind the seatback straight back, then up. While moving the lever up, simultaneously lift the seat to remove.
Removing the second center seat (if equipped)
- Pull the lock release strap
and fold down the second
center seatback.
Make sure that the head restraint is in the lowest position.
- Pull the lock release strap
under the seat to remove the
seat.
Retract the cushion leg.
- Stow the seat in the storage
box of the luggage room
(cushion side first).
Engage the stow latch buckle to hold the seat and tighten the latch strap.
Moving a second seat for third seat access
Getting in the vehicle
Tip-up seats
Pull the seatback angle adjustment
lever and fold down the
seatback. The cushion will tip
up. The seat can slide forward.
Move the seat to the fron ...
Installing the second seats
Installing the second outside seats
Align the marking on the seat side cover to the marking on the
rail cover and align the marking on the seat front/back cover to
the rail.
Tip-up seat
...
Other materials:
Installation
1. INSTALL STARTER ASSEMBLY
(a) Install the starter with the 2 bolts.
Torque: 37 N*m (380 kgf*cm, 26 ft.*lbf) for bolt
(b) Connect the starter connector.
(c) Install the terminal nut and cover the nut with the
cap.
Torque: 9.8 N*m (100 kgf*cm, 7 ft.*lbf) for nut
2. INSTALL NO. 1 ...
Removal
1. RECOVER REFRIGERANT FROM REFRIGERATION
SYSTEM (See page AC-172)
2. REMOVE FRONT WHEEL RH
3. REMOVE FRONT FENDER APRON SEAL RH (See
page EM-26)
4. REMOVE V-RIBBED BELT (See page EM-6)
5. REMOVE RADIATOR AND FAN ASSEMBLY
(See page CO-28)
6. DISCONNECT DISCHARGE HOSE SUB-ASSEMBLY
(a) Re ...
Disassembly
1. REMOVE FRONT SEAT SIDE TABLE LEG COVER (w/
Table)
Using a screwdriver, disengage the claws and
remove the seat side table leg cover.
HINT:
Tape the screwdriver tip before use.
2. REMOVE FRONT SEAT SIDE TABLE (w/ Table)
Remove the 4 nuts and seat side table.
Rem ...
