Toyota Sienna Service Manual: Repair instruction

Identification information

VEHICLE IDENTIFICATION AND SERIAL NUMBERS 1. VEHICLE IDENTIFICATION NUMBER (a) The vehicle identification number is stamped on the vehicle identification number plate and the certification label, ...

Precaution

...

Other materials:

Installation
1. INSTALL BRAKE PEDAL SUPPORT ASSEMBLY (a) Install the brake pedal support sub-assembly with the 4 nuts. Torque: 16 N*m (160 kgf*cm, 12 ft.*lbf) (b) Install the clip and clevis pin to the brake pedal lever. (c) Using needle-nose pliers, install the tension spring. (d) Install the ...

On-vehicle inspection
1. INSPECT SIDE AIRBAG SENSOR (VEHICLE NOT INVOLVED IN COLLISION)  Perform a diagnostic system check. 2. INSPECT SIDE AIRBAG SENSOR (VEHICLE INVOLVED IN COLLISION AND AIRBAG HAS NOT DEPLOYED)  Perform a diagnostic system check.  When the center pillar of the vehicle or ...

Absence of Registration Unit/ No Response for Connection Check/ Last Mode Error/ No Response Against ON / OFF Command/ Mode Status Error/ Slave Reset
DESCRIPTION HINT:  *1: Even if no fault is present, this trouble code may be stored depending on the battery condition or engine start voltage.  *2: If the power connector is disconnected after the engine starts, this code is stored after 180 seconds.  *3: If the ...