Toyota Sienna 2010-2026 Owners Manual: Sliding doors

Toyota Sienna 2010-2026 Owners Manual / Operation of each component / Opening, closing and locking the doors / Sliding doors

Vehicles without power sliding doors The sliding doors can be opened and closed using the sliding door handle. The sliding door can be locked and unlocked using the wireless remote control, door lock switch or inside lock knob.
Vehicles with power sliding doors The power sliding doors can be opened and closed using the sliding door handle, power sliding door switches or wireless remote control. The power sliding doors can be locked and unlocked using the wireless remote control, door lock switch or inside lock knob.

Automatic door locking and unlocking systems

The following functions can be set or cancelled: For instructions on customizing, refer to Function Operation Shift position linked door locking function Shifting the shif ...

Locking/unlocking the sliding door from

Entry function (vehicles with a smart key system) Carry the electronic key to enable this function. Pull the handle to unlock all the doors. There is no touch type sensor in slide door ha ...

Other materials:

Active Control Engine Mount System
DESCRIPTION LOCATION The Active Control Engine Mount (ACM) system decreases engine vibration at engine idling using the ACM VSV. The VSV is controlled by a pulse signal transmitted to the VSV from the ECM. The frequency of this pulse signal is matched to the engine speed to decrease engi ...

Approach warning
When your vehicle is too close to a vehicle ahead, and sufficient automatic deceleration via the cruise control is not possible, the display will flash and the buzzer will sound to alert the driver. An example of this would be if another driver cuts in front of you while you are following a vehi ...

Terminals of ECU
1. CHECK POWER BACK DOOR ECU Disconnect the P13 and P14 ECU connectors, and check the voltage or resistance of each terminal of the wire harness side connectors If the result is not as specified, there may be a malfunction on the wire harness side. Reconnect the ECU connector ...