Toyota Sienna 2010-2026 Owners Manual: Headlight switch
The headlights can be operated manually or automatically.
- Operating instructions
- Turning on the high beam headlights
- Manual headlight leveling dial (vehicles with discharge headlights)
Operating instructions
Turning the end of the lever turns on the lights as follows:
The illustration is intended as an example.
U.S.A.
Canada
The headlights, side marker,
parking lights, daytime ...
Other materials:
Installation
1. INSTALL FRONT DRIVE SHAFT ASSEMBLY LH
(a) Coat the spline of the inboard joint shaft assembly
with ATF.
(b) Align the shaft splines and install the drive shaft
assembly with a brass bar and hammer.
NOTICE:
Set the snap ring with the opening side facing
down.
Be careful not to d ...
Canceling and resuming the constant speed control
Pulling the lever toward you
cancels the constant speed
control.
The speed setting is also canceled
when the brakes are applied.
Pushing the lever up resumes
the constant speed control.
Resuming is available when the
vehicle speed is more than approximately
25 mph (40 km/h). ...
TC and CG Terminal Circuit
DESCRIPTION
Connecting terminals TC and CG of the DLC3 causes the system to enter the
self-diagnostic mode. If a
malfunction is present, DTCs will be output.
HINT:
When a particular warning light remains blinking, a ground short in the wiring
of terminal TC of the DLC3
or an internal ground ...
