Toyota Sienna Service Manual: Air inlet control servo motor

For manual air conditioning system

ON-VEHICLE INSPECTION 1. INSPECT BLOWER RESISTOR (for Manual Air Conditioning System) (a) Measure resistance between terminals, as shown in the table. If resistance is not as specified, replac ...

For automatic air conditioning system

ON-VEHICLE INSPECTION 1. INSPECT AIR INLET CONTROL SERVO MOTOR (a) Remove the air inlet control servo motor. (b) Connect the positive (+) lead from the battery to terminal 4 and negative (-) ...

Other materials:

Removal
1. REMOVE GLOVE COMPARTMENT DOOR STOPPER SUB-ASSEMBLY 2. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY 3. REMOVE STEREO COMPONENT AMPLIFIER ASSEMBLY (W/ STEREO COMPONENT AMPLIFIER) 4. REMOVE DISTANCE CONTROL ECU ASSEMBLY  Remove the bolt.  Disengage the clip and remove the distanc ...

Gateway ECU Communication Stop Mode
DESCRIPTION Detection Item Symptom Trouble Area Gateway ECU Communication Stop Mode "Gateway" is not displayed on the "Communication Bus Check" screen of the intelligent tester Applies to "Gateway ECU Communication ...

Canceling the power sliding door system (vehicles with power sliding doors)
Turn the main switch off to disable the power sliding door system. Off The sliding doors can only be opened and closed manually. On* The power sliding door can be opened and closed with the power sliding door switches for the front occupants or wireless remote control even if ...