Toyota Sienna 2010-2026 Owners Manual: Automatic transaxle

When stopping the engine with the shift lever in a position other than P

If the engine is stopped with the shift lever in a position other than P, the engine switch will not be turned off but instead be turned to ACCESSORY mode. Perform the following procedure to turn th ...

Shifting the shift lever

While the engine switch is in the “ON” position (vehicles without a smart key system) or IGNITION ON mode (vehicles with a smart key system), move the shift lever with the brake pedal de ...

Other materials:

Short to B+ in Curtain Shield Squib LH Circuit
DTC B1168/86 Short to B+ in Curtain Shield Squib LH Circuit DESCRIPTION The curtain shield squib LH circuit consists of the center airbag sensor assembly and the curtain shield airbag assembly LH. The circuit instructs the SRS to deploy when deployment conditions are met. DTC B1168/86 is ...

DTC check / clear
1. CHECK DTC (USING INTELLIGENT TESTER) Checking DTCs. Connect the intelligent tester to the DLC3. Turn the ignition switch ON. Read DTCs by following the prompts on the tester screen. HINT: Refer to the intelligent tester operator's manual for further details. 2. CLEAR DTC ...

Installation
HINT: Install the RH side by the same procedure as the LH side. 1. INSTALL REAR SPEED SENSOR (a) Clean the contacting surface of the axle hub and a new skid control sensor. NOTICE: Keep the sensor rotor clean. (b) Place the speed sensor on the axle hub so that the connector is positioned ...