Toyota Sienna Service Manual: Ignition key cylinder light
ON-VEHICLE INSPECTION
1. KEY CYLINDER LIGHT ASSEMBLY
- Connect the battery positive (+) lead to the terminal 1 and the battery negative (-) lead to the terminal 2, and check that the indicator light comes on.
2. TRANSPONDER KEY AMPLIFIER
- Inspect key cylinder light operation.
- Connect the battery positive (+) lead to the terminal 2 and the battery negative (-) lead to the terminal 6, and check that the indicator light comes on.
Door courtesy light (for Rear
Side)
ON-VEHICLE INSPECTION
1. REAR DOOR COURTESY LIGHT ASSEMBLY LH
Check that the exists between the terminals.
Resistance:
Below 1 Ω
2. REAR DOOR COURTESY LIGHT ASSEMBLY RH
...
Vanity light
ON-VEHICLE INSPECTION
1. LH VISOR ASSEMBLY
Inspect vanity light resistance.
check that the resistance exists between the
terminal 1 and the terminal 2 when the light is
oper ...
Other materials:
System description
1. GENERAL DESCRIPTION
The power seat control system is equipped with the
following function:
The front seats are equipped with electric
adjuster slide, reclining, lifter, front vertical and
lumbar support adjustment functions.
The power seat control system (w ...
Perform monitor drive pattern
The monitor results and test values can be checked with
the OBD II scan tool or the intelligent tester. The engine
control module (ECM) monitors the emissions-related
components such as the thermostat, catalyst converter
and evaporative emissions (EVAP), and determines
whether they are function ...
Evap monitor (key-off type)
(a) Preconditions
The monitor will not run unless:
The fuel tank is less than 90% full.
The altitude is less than 8000 ft (2450 m).
The vehicle is stationary.
The engine coolant temperature is between
4.4°C and 35°C (40°F and 95°F).
The intake air temperature is between 4.4°C and ...
