Toyota Sienna 2010-2026 Owners Manual: Before refueling the vehicle

Toyota Sienna 2010-2026 Owners Manual / Driving / Refueling / Before refueling the vehicle

Close all the doors and windows, and turn the engine switch to the “LOCK” position (vehicles without a smart key system) or off (vehicles with a smart key system).
Confirm the type of fuel.

Fuel type

Fuel tank opening for unleaded gasoline

To help prevent incorrect fueling, your vehicle has a fuel tank opening that only accommodates the special nozzle on unleaded fuel pumps.

WARNING

When refueling the vehicle

Observe the following precautions while refueling the vehicle. Failure to do so may result in death or serious injury.

After exiting the vehicle and before opening the fuel door, touch an unpainted metal surface to discharge any static electricity. It is important to discharge static electricity before refueling because sparks resulting from static electricity can cause fuel vapors to ignite while refueling.
Always hold the grips on the fuel tank cap and turn it slowly to remove it.
A whooshing sound may be heard when the fuel tank cap is loosened.
Wait until the sound cannot be heard before fully removing the cap.
In hot weather, pressurized fuel may spray out of the filler neck and cause injury.
Do not allow anyone that has not discharged static electricity from their body to come close to an open fuel tank.
Do not inhale vaporized fuel.
Fuel contains substances that are harmful if inhaled.
Do not smoke while refueling the vehicle.
Doing so may cause the fuel to ignite and cause a fire.
Do not return to the vehicle or touch any person or object that is statically charged.
This may cause static electricity to build up, resulting in a possible ignition hazard.

When refueling

Observe the following precautions to prevent fuel overflowing from the fuel tank:

Securely insert the fuel nozzle into the fuel filler neck.
Stop filling the tank after the fuel nozzle automatically clicks off.
Do not top off the fuel tank.

NOTICE

Refueling

Do not spill fuel during refueling.

Doing so may damage the vehicle, such as causing the emission control systems to operate abnormally or damaging fuel system components or the vehicle’s painted surface.

Refueling

Perform the following steps to open the fuel tank cap: ...

Opening the fuel tank cap

Pull up the opener to open the fuel filler door. Turn the fuel tank cap slowly to remove it and hang it on the back of the fuel filler door ...

Other materials:

On-vehicle inspection
1. INSPECT SPEEDOMETER Check the operation. Using a speedometer tester, check the speedometer indication according to the table below. Reference: mph (U.S.A.) Reference: km/h (Canada) NOTICE: Tire wear as well as over or under inflation will cause errors. ...

Pressure Control Solenoid "D" Performance (Shift Solenoid Valve SLT)
SYSTEM DESCRIPTION The linear solenoid valve (SLT) controls the transmission line pressure for smooth transmission operation based on signals from the throttle position sensor and the vehicle speed sensor. The ECM adjusts the duty ratio (*) of the SLT solenoid valve to control hydraulic line ...

Check mode procedure
1. CHECK MODE (SIGNAL CHECK): DTC CHECK Connect the intelligent tester to the DLC3. ) Turn the ignition switch to the ON position. ) Select the "SIGNAL CHECK", and proceed checking using the intelligent tester. NOTICE: Select the "SIGNAL CHECK" from the &q ...