Toyota Sienna Service Manual: Brake system

Installation

1. INSTALL STEERING ANGLE SENSOR (a) Install the steering sensor onto the spiral cable. 2. PLACE FRONT WHEELS FACING STRAIGHT AHEAD 3. INSTALL SPIRAL CABLE SUB-ASSEMBLY (See page RS-434) 4. I ...

Precaution

Care must be taken to replace each part properly as it could affect the performance of the brake system and result in a driving hazard. Replace the parts with parts having the same part numbe ...

Other materials:

On-vehicle inspection
1. INSPECT STEERING PAD (VEHICLE NOT INVOLVED IN COLLISION) Perform a diagnostic system check. With the steering pad installed on the vehicle, perform a visual check. If there are any defects as mentioned below, replace the steering pad with a new one: Cuts, minute cracks or marked ...

Camshaft Position Sensor "A" Circuit
DTC P0340 Camshaft Position Sensor "A" Circuit (Bank 1 or Single Sensor) DTC P0342 Camshaft Position Sensor "A" Circuit Low Input (Bank 1 or Single Sensor) DTC P0343 Camshaft Position Sensor "A" Circuit High Input (Bank 1 or Single Sensor) DTC P0345 Camshaft Posit ...

Crankshaft position sensor
Components Removal 1. Remove compressor and magnetic clutch HINT: (See page AC-227 ) 2. REMOVE CRANKSHAFT POSITION SENSOR (a) Disconnect the crankshaft position sensor connector. (b) Remove the bolt, and then remove the crankshaft position sensor. INSPECTION 1. INSPECT CRANKSHAFT ...