Toyota RAV4 manuals

Toyota Sienna Service Manual: CD-ROM Abnormal/ CD-ROM Abnormal

DTC 62-43 CD-ROM Abnormal

DTC 63-43 CD-ROM Abnormal

DESCRIPTION

DTC No.

DTC Detecting Condition

Trouble Area

62-43 CD-ROM operation is abnormal
  • CD
  • Radio receiver
63-43 CD-ROM operation is abnormal

INSPECTION PROCEDURE

HINT: After the inspection is completed, clear the DTCs.

1 CHECK IF A PROPER CD IS INSERTED

  1. Make sure that the CD is an audio CD or a CD with an MP3 or WMA file, and that it is not deformed, flawed, stained, burred, or otherwise defective.

OK: Normal CD

HINT:

2 REPLACE CD WITH ANOTHER AND RECHECK

  1. Replace the CD with another and recheck.
  1. Replace the CD with another normal one.
  2.  Clear the DTCs.
  3.  Recheck for DTCs and check if the same trouble occurs again.

OK: Malfunction disappears

END

Wrong Disc/ Disc cannot be Read/ Wrong Disc/ Disc cannot be Read
DTC 62-41 Wrong Disc DTC 62-42 Disc cannot be Read DTC 63-41 Wrong Disc DTC 63-42 Disc cannot be Read DESCRIPTION DTC No. DTC Detecting Condition Trouble Area 62 ...

CD Abnormal/ Excess Current/ Tray Insertion / Ejection Error/ CD Abnormal/ Excess Current/ Tray Insertion / Ejection Error
DTC 62-44 CD Abnormal DTC 62-48 Excess Current DTC 62-50 Tray Insertion / Ejection Error DTC 63-44 CD Abnormal DTC 63-48 Excess Current DTC 63-50 Tray Insertion / Ejection Error DESCRIPTION ...

Other materials:

Disassembly
1. FIX FRONT SHOCK ABSORBER WITH COIL SPRING (a) Install 2 nuts and a bolt to the bracket at the lower side of the front shock absorber with coil spring and secure it in a vise. 2. REMOVE FRONT SUSPENSION SUPPORT SUBASSEMBLY LH (a) Using SST, compress the front coil spring LH SST 09727-300 ...

Inspection
1. INSPECT PACK CLEARANCE OF FORWARD CLUTCH (a) Install the forward clutch on the oil pump. NOTICE: Be careful not to damage the oil seal ring of oil pump. b) Using a dial indicator, measure the forward clutch pack clearance while applying and releasing compressed air (392 kPa, 4.0 kgf/cm ...

On-vehicle inspection
1. CHECK VVT SENSOR OUTPUT VOLTAGE Turn the ignition switch to the ON position. Check the voltage between the specified terminal and body ground. Standard voltage While turning the crankshaft pulley by hand, measure the voltage between each terminal. Check that the voltage ...

В© 2011-2026 Copyright www.tsienna.net