Toyota Sienna Service Manual: CD Abnormal/ Excess Current/ Tray Insertion / Ejection Error/ CD Abnormal/ Excess Current/ Tray Insertion / Ejection Error
DTC 62-44 CD Abnormal
DTC 62-48 Excess Current
DTC 62-50 Tray Insertion / Ejection Error
DTC 63-44 CD Abnormal
DTC 63-48 Excess Current
DTC 63-50 Tray Insertion / Ejection Error
DESCRIPTION
|
DTC No. |
DTC Detecting Condition |
Trouble Area |
| 62-44 | Operation error in the CD mechanism | Radio receiver |
| 62-48 | Excess current is present in the CD player | |
| 62-50 | Malfunction in insertion/ejection system | |
| 63-44 | Operation error in the CD mechanism | |
| 63-48 | Excess current is present in the CD changer | |
| 63-50 | Malfunction in insertion/ejection system |
INSPECTION PROCEDURE
HINT: After the inspection is completed, clear the DTCs.
1 CLEAR DTC
- Clear the DTCs
2 RECHECK DTC
- Recheck for DTCs and check if the same trouble occurs again.
HINT: If DTCs are detected frequently, replace the radio receiver.
OK: Malfunction disappears
END
CD-ROM Abnormal/ CD-ROM Abnormal
DTC 62-43 CD-ROM Abnormal
DTC 63-43 CD-ROM Abnormal
DESCRIPTION
DTC No.
DTC Detecting Condition
Trouble Area
62-43
CD-ROM operation is abnormal
CD
R ...
Eject Error/ Elevator Error/ Clamp Error/ Eject Error/ Elevator Error/ Clamp
Error
DTC 62-45 Eject Error
DTC 62-51 Elevator Error
DTC 62-52 Clamp Error
DTC 63-45 Eject Error
DTC 63-51 Elevator Error
DTC 63-52 Clamp Error
DESCRIPTION
DTC No.
DTC Detecting Con ...
Other materials:
Reassembly
1. INSTALL FRONT DOOR WIRE LH
Install the wire with the 2 bolts.
Torque: Reference
8.0 N*m (82 kgf*cm, 71 in.*lbf)
NOTICE:
In order to prevent water leakage, be sure that
the lip of the rubber grommet does not turn up
or is not deformed when installing the wire.
Connect the wir ...
Gyro Error
DTC 58-10 Gyro Error
DTC 80-10 Gyro Error
DESCRIPTION
DTC No.
DTC Detection Condition
Trouble Area
58-10
Ground short, power supply short, or open circuit in the
gyro signal
Gyro sensor
Radio and navigation assembly
80-10
...
Cruise Main Indicator Light Circuit
DESCRIPTION
The ECM detects a cruise control switch signal and sends it to the
combination meter through CAN
and BEAN. Then the CRUISE main indicator light comes on.
The CRUISE main indicator light circuit uses CAN and BEAN for
communication. If there is a
malfunction in ...
