Toyota Sienna Service Manual: Center airbag sensor assembly

Disposal

HINT:  Use the same procedures for the RH side and LH side.  The procedures listed below are for the LH side.  When scrapping a vehicle equipped with the SRS or disposing of t ...

On-vehicle inspection

1. INSPECT CENTER AIRBAG SENSOR ASSEMBLY (VEHICLE NOT INVOLVED IN COLLISION)  Perform a diagnosis system check. 2. INSPECT CENTER AIRBAG SENSOR ASSEMBLY (VEHICLE INVOLVED IN COLLISION AN ...

Other materials:

On-vehicle inspection
HINT: The type of ignition switch on this model differs according to the specifications of the vehicle. For the expressions used in this section, refer to the "EXPRESSIONS OF IGNITION SWITCH" precaution (See page ES-1). 1. CHECK AIR FUEL RATIO COMPENSATION SYSTEM (a) Connect the inte ...

Lubrication system
On-vehicle inspection 1. CHECK ENGINE OIL LEVEL (a) Warm up the engine, stop it and wait 5 minutes. The oil level should be between the dipstick's low level mark and full level mark. If the engine oil level is low, check for leakage and add oil up to the full level mark. NOTICE: D ...

System Voltage
MONITOR DESCRIPTION The battery supplies electricity to the ECM even when the ignition switch is off. This power allows the ECM to store data such as DTC history, freeze frame data and fuel trim values. If the battery voltage falls below a minimum level, these memories are cleared and the ...