Toyota Sienna Service Manual: Supplemental restraint system
- Airbag system
- Precaution
- Parts location
- System description
- How to proceed with troubleshooting
- Problem symptoms table
- Terminals of ECU
- Diagnosis system
- DTC check / clear
- Check mode procedure
- Data list / active test
- Diagnostic trouble code chart
- Occupant classification system
- Precaution
- System description
- How to proceed with troubleshooting
- Initialization
- Problem symptoms table
- Terminals of ECU
- Diagnosis system
- DTC check / clear
- Data list / active test
- Diagnostic trouble code chart
- Steering pad
- Spiral cable
- Front passenger airbag assembly
- Curtain shield airbag assembly
- Front seat side airbag assembly
- Center airbag sensor assembly
- Front airbag sensor
- Side airbag sensor
- Rear airbag sensor
- Seat position sensor
- Occupant classification ecu
Air fuel ratio sensor relay
INSPECTION
1. INSPECT AIR FUEL RATIO SENSOR RELAY
Using an ohmmeter, measure the resistance
according to the value(s) in the table below.
Standard resistance
If the result is ...
Airbag system
...
Other materials:
Removal
1. REMOVE REAR WHEEL
2. REMOVE TAIL EXHAUST PIPE ASSEMBLY (See page
EX-8)
3. SEPARATE REAR SPEED SENSOR
(a) Remove the bolt and the speed sensor from the
axle carrier.
NOTICE:
Be careful not to damage the speed sensor
Prevent foreign matter from adhering to the
speed sensor.
4. REMO ...
For driver side
ON-VEHICLE INSPECTION
1. INSPECT AIR MIX CONTROL SERVO MOTOR
(a) Remove the air mix control servo motor.
(b) Connect the positive (+) lead from the battery to
terminal 4 and negative (-) lead to terminal 5, then
check that the lever turns to "COOL" side smoothly.
(c) Connect ...
Driving position memory
Your preferred driving position (the position of the driver’s seat and
outside rear view mirrors) can be recalled by pressing a button.
Two different driving positions can be recorded into memory.
Recording procedure
Check that the shift lever is in P.
Turn the engine switch to IGNI ...
