Toyota Sienna Service Manual: Components

Throttle body

...

On-vehicle inspection

1. INSPECT THROTTLE BODY  Listen to the throttle control motor operating sounds.  Turn the ignition switch to the ON position. When pressing the accelerator pedal position sens ...

Other materials:

Automatic Light Control Sensor Circuit
DESCRIPTION The Multiplex network body ECU receives the signal from the automatic light control sensor. HINT: DTC code is output when malfunction of automatic light control sensor or open or short of automatic light control sensor circuit occurs. WIRING DIAGRAM INSPECTION PROCEDURE ...

Power Slide Door LH does not Operate When Using Inside / Outside Handle
DESCRIPTION  The inside / outside handles have the ability to control operation of the power slide door. Pulling either handle transmits a request signal to the power slide door ECU LH, which then commands the power slide door control motor and clutch to open / close the power sli ...

Removal
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 2. REMOVE FRONT DOOR SCUFF PLATE LH 3. REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH 4. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH (See page IP-6) 5. REMOVE TIRE PRESSURE WARNING RESET SWITCH (a) Disengage the 2 claws and remove t ...