Toyota Sienna Service Manual: 2GR-FE Engine control system
- SFI system
- Precaution
- Definition of terms
- How to proceed with troubleshooting
- Check for intermittent problems
- Basic inspection
- Registration
- Checking monitor status
- Readiness monitor drive pattern
- Problem symptoms table
- Terminals of ECM
- Diagnosis system
- DTC check / clear
- Freeze frame data
- Check mode procedure
- Fail-safe chart
- Data list / active test
- Diagnostic trouble code chart
- Camshaft timing oil control valve assembly
- Throttle body
- ECM
- Accelerator pedal rod
- Mass air flow meter
- VVT sensor
- Engine coolant temperature sensor
- Knock sensor
- EFI relay
- Circuit opening relay
- Air fuel ratio sensor relay
Inspection
1. INSPECT GARAGE DOOR OPENER
Press the switch and check that each red LED turns
on. If one or more of the switches does not turn on
the LED, confirm normal operation of the fuse and ...
SFI system
...
Other materials:
Inspection
1. INSPECT FUEL INJECTOR ASSEMBLYV
(A) inspect the injector resistance.
(1) Using an ohmmeter, measure the resistance
between the terminals.
Standard resistance
If the resistance is not as specified, replace the
injector.
(b) Inspect the injection volume.
CAUTION:
This test ...
CD Abnormal/ Excess Current/ Tray Insertion / Ejection Error
DTC 63-44 CD Abnormal
DTC 63-48 Excess Current
DTC 63-50 Tray Insertion / Ejection Error
DESCRIPTION
DTC No.
DTC Detection Condition
Trouble Area
63-44
Operation error in the CD mechanism
Radio and navigation assembly
63-48
Excess current is pr ...
Installation
1. INSTALL COMPRESSOR AND MAGNETIC CLUTCH
(a) Using a "TORX" socket wrench (E8), install the
compressor and magnetic clutch with the 2 stud
bolts.
Torque: 10 N*m (102 kgf*cm, 7.4 ft.*lbf)
HINT:
Tighten the stud bolts in the order shown in the
illustration.
(b) Install the c ...
