Toyota Sienna 2010-2026 Owners Manual: Console box

Toyota Sienna 2010-2026 Owners Manual / Interior features / Using the storage features / List of storage features / Console box

Press the tab.

Type A

Toyota Sienna. Console box

Type B

Toyota Sienna. Console box

Sliding the console box (type B)

From front

Toyota Sienna. Sliding the console box

Press the tab and slide the console box.

From rear

Toyota Sienna. Sliding the console box

Pull up the lever and slide the console box.

Console box light

The console box light turns on when the headlight switch is on.

WARNING

Console box adjustment precaution (type B)

Do not adjust the position of the console box while the vehicle is moving.
This may cause the driver to mishandle the vehicle and may lead to an accident that results in death or serious injury.
Be careful not to get hands or feet pinched between the console box and the rear sliding console or rear seat.
Be careful not to allow the console box to hit any passenger while adjusting its position.
After adjusting the console box, make sure it is securely locked in position.

Glove boxes

Upper glove box Push the button. Open the lid. Lower glove box The lower glove box can be opened by pulling the lever and can be locked and unlocked by using the master key (v ...

Cup holders

Front Press in and release the front cup holder. Console box type A (if equipped) Console box type B (if equipped) Pull the lid down. Console box type C (if e ...

Other materials:

Disassembly
1. REMOVE REAR DOOR WINDOW FRAME MOULDING REAR LH (See page ET-31) 2. REMOVE REAR DOOR WINDOW FRAME MOULDING SUB-ASSEMBLY LH (See page ET-32) 3. REMOVE SLIDE DOOR WINDOW GARNISH LH Fully open the slide door window. Remove the glass run. Using a screwdriver, disengage the clip and rem ...

Installation
1. Install generator assembly (a) Install the bracket with the bolt. Torque: 20 N*m (204 kgf*cm, 15 ft.*lbf) (b) Install the wire harness clamp stay. Torque: 8.4 N*m (86 kgf*cm, 74 in.*lbf) (c) Connect the wire harness clamp. (d) Install the generator assembly to the cylinder ...

Yaw Rate Sensor Communication Stop Mode
DESCRIPTION Detection Item Symptom Trouble Area Yaw Rate Sensor Communication Stop Mode "Yaw rate/ Deceleration sensor" is not displayed on the "Communication Bus Check" screen of the intelligent tester Applies to & ...