Toyota Sienna Service Manual: Fog light assembly

Daytime running light resister

On-vehicle inspection 1. DRL RESISTOR  Check that there is resistance between the terminals as shown in the chart. Resistance ...

Components

REMOVAL 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 2. REMOVE FRONT BUMPER ASSEMBLY 3. REMOVE FOG LIGHT ASSEMBLY  Disengage the 2 claws  Disengage the 2 pins and rem ...

Other materials:

If you have a flat tire (vehicles with a compact spare tire)
Your vehicle is equipped with a spare tire. The flat tire can be replaced with the spare tire. For details about tires: WARNINGIf you have a flat tire Do not continue driving with a flat tire. Driving even a short distance with a flat tire can damage the tire and the wheel ...

Installation
1. INSTALL REAR NO. 1 SEAT ASSEMBLY LH  Place the seat in the cabin. NOTICE: Be careful not to damage the body.  Install the seat.  7-Passenger RH: Install the seat belt anchor plate with the bolt. Torque: 42 N*m (428 kgf*cm, 31 ft.*lbf)  Install the headrest. ...

Removal
1. Remove rear wheel 2. Remove skid control sensor wire (for 2wd) Hint: (see page sp-38) hint: disconnect the rh side by the same procedures as the lh side. 3. SEPARATE SPEED SENSOR REAR LH (for 4WD) HINT: (See page SP-38) 4. SEPARATE SPEED SENSOR REAR RH (for 4WD) HINT: Separate the RH ...