Toyota RAV4 manuals

Toyota Sienna Service Manual: For vehicles equipped with catalytic converter

Toyota Sienna Service Manual / Introduction / Repair instruction / Precaution / For vehicles equipped with catalytic converter

CAUTION: If a large amount of unburned gasoline or gasoline vapors flow into the converter, it may cause overheating and create a fire hazard. To prevent this, observe the following precautions:

(a) Use only unleaded gasoline.

(b) Avoid idling the engine for more than 20 minutes.

(c) Avoid performing unnecessary spark jump tests.

(1) Perform a spark jump test only when absolutely necessary. Perform this test as rapidly as possible.

(2) While testing, never race the engine.

(d) Avoid a prolonged engine compression measurement. Engine compression measurements must be performed as rapidly as possible.

(e) Do not run the engine when the fuel tank is nearly empty. This may cause the engine to misfire and create an extra load on the converter.

When towing full-time 4wd vehicles
Use one of the methods shown below to tow the vehicle. If the vehicle has trouble with the chassis or drive train, use method 1 (flat bed truck). WHEN TOWING FULL-TIME 4WD VEHICLES ...

Precaution for cooling fan system
NOTICE: • When the ignition switch is turned off and the engine temperature is high, the cooling fans may operate for approximately 3 minutes. • After turning the ignition switch off, ke ...

Other materials:

Removal
1. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP LH 2. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP RH 3. REMOVE FRONT PILLAR GARNISH LH 4. REMOVE FRONT PILLAR GARNISH RH 5. REMOVE VISOR ASSEMBLY LH 6. REMOVE VISOR ASSEMBLY RH 7. REMOVE ASSIST GRIP SUB-ASSEMBLY (2) 8. REMOVE VISOR HOLDER (1) ...

On-vehicle inspection
1. INSPECT SEAT POSITION SENSOR (VEHICLE NOT INVOLVED IN COLLISION)  Perform a diagnostic system check. 2. INSPECT SEAT POSITION SENSOR (VEHICLE INVOLVED IN COLLISION)  Perform a diagnostic system check.  Even if the airbag was not deployed, check if there is any dama ...

Selecting conventional constant speed control mode
Constant speed control mode differs from vehicle-to-vehicle distance control mode. When constant speed control mode is selected, your vehicle will maintain a set speed regardless of whether or not there are other vehicles in the lane ahead. Press the “ON-OFF� button to activate the ...

© 2011-2026 Copyright www.tsienna.net