Toyota Sienna Service Manual: On-vehicle inspection

Toyota Sienna Service Manual / Supplemental restraint system / Side airbag sensor / On-vehicle inspection

1. INSPECT SIDE AIRBAG SENSOR (VEHICLE NOT INVOLVED IN COLLISION)

Perform a diagnostic system check.

2. INSPECT SIDE AIRBAG SENSOR (VEHICLE INVOLVED IN COLLISION AND AIRBAG HAS NOT DEPLOYED)

Perform a diagnostic system check.
When the center pillar of the vehicle or its area is damaged, check if there is any damage to the side airbag sensor. If there are any defects as mentioned below, replace the side airbag sensor with a new one:

Cracks, dents or chips on the sensor housing.
Cracks or other damage to the connector.
Peeling off of the label or damage to the serial number.

CAUTION: Be sure to follow the correct removal and installation procedures.

3. INSPECT SIDE AIRBAG SENSOR (VEHICLE INVOLVED IN COLLISION AND AIRBAG HAS DEPLOYED)

Replace the side airbag sensor.

CAUTION: Be sure to follow the correct removal and installation procedures.

HINT: The side airbag sensor on the impacted side should be replaced after the front seat side airbag assembly and curtain shield airbag assembly have deployed.

Removal

HINT: Use the same procedures for the RH side and LH side. The procedures listed below are for the LH side. 1. PRECAUTION CAUTION: Be sure to read "PRECAUTION" thoroug ...

Other materials:

Inspection
1. INSPECT STEERING PAD SWITCH LH (w/o Navigation System) Measure the resistance according to the values in the table below. Standard resistan If the result is not as specified, replace the steering pad switch LH. 2. INSPECT STEERING PAD SWITCH RH (w/ Navigation System) ...

Turning the high beam on/off manually
Switching to low beam Pull the lever to the original position. Switching to high beam Turn the light switch to the position. The Automatic High Beam can be operated when The engine switch is in the “ON” position (vehicles without a smart key system) or IGNITION ON mode (vehicl ...

Air outlet control servo motor (for rear air conditioning system)
ON-VEHICLE INSPECTION 1. INSPECT REAR AIR OUTLET CONTROL SERVO MOTOR (a) Inspect servo motor operation. (1) Connect the positive (+) lead from the battery to terminal 4 and negative (-) lead to terminal 5, then check that the arm turns to "FOOT" side smoothly. (2) Connect t ...