Toyota Sienna Service Manual: Front seat inner belt assembly

Seat belt warning system

PARTS LOCATION Problem symptoms table SEAT BELT WARNING SYSTEM Symptom Suspected Area Driver side seat belt waning light does not operate Fuse Combina ...

Removal

1. REMOVE FRONT SEAT INNER BELT ASSEMBLY HINT:  Refer to the instructions for disassembly of the front seat assembly (for flat type).  Refer to the instructions for disassembly of t ...

Other materials:

For manual air conditioning system
ON-VEHICLE INSPECTION 1. INSPECT AIR INLET CONTROL SERVO MOTOR (a) Remove the air inlet control servo motor. (b) Connect the positive (+) lead from the battery to terminal 5 and negative (-) lead to terminal 1, then check that the lever turns to "RECIRCULATION" side smoothly. ...

TC and CG Terminal Circuit
DESCRIPTION Connecting terminals TC and CG of the DLC3 causes the system to enter the self-diagnostic mode. If a malfunction is present, DTCs will be output. HINT: When a particular warning light remains blinking, a ground short in the wiring of terminal TC of the DLC3 or an internal ground ...

Reassembly
1. INSTALL STRAIGHT PIN (a) Using a plastic hammer, tap in new straight pins to the cylinder block. Standard protrusion 2. INSTALL STUD BOLT (a) Using E8 and E10 "TORX" sockets, install the stud bolts. Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf) for bolt A 17 N*m (173 kgf*cm, ...