Toyota Sienna Service Manual: Seat belt
- Seat belt warning system
- Front seat inner belt assembly
- Front seat outer belt assembly
- Rear seat inner belt assembly
- Rear seat outer belt assembly
- Rear center seat inner belt assembly
- Rear center seat outer belt assembly
Installation
1. INSTALL INSTRUMENT PANEL SAFETY PAD SUBASSEMBLY
Using a torque wrench, install the bolt <B>.
Torque: 20 N*m (204 kgf*cm, 14 ft.*lbf)
2. INSTALL SHIFT LEVER ASSEMBLY
...
Seat belt warning system
PARTS LOCATION
Problem symptoms table
SEAT BELT WARNING SYSTEM
Symptom
Suspected Area
Driver side seat belt waning light does not operate
Fuse
Combina ...
Other materials:
Problem symptoms table
Use the table below to find the cause of the problem. The
numbers indicate the priority of the likely cause of the
problem. Check each part in order. If necessary, replace
these parts.
Front A/C:
Rear A/C:
...
For rear air conditioning system
ON-VEHICLE INSPECTION
1. INSPECT REAR AIR MIX CONTROL SERVO MOTOR
(a) Inspect servo motor operation.
(1) Connect the positive (+) lead from the battery
to terminal 4 and negative (-) lead to terminal 5,
then check that the arm turns to "HOT" side
smoothly.
(2) Connect the po ...
Removal
HINT:
Use the same procedures for the RH side and LH side.
The procedures listed below are for the LH side.
1. PRECAUTION
CAUTION:
Be sure to read "PRECAUTION" thoroughly before servicing.
2. DISCONNECT CABLE FROM NEGATIVE BATTERY
TERMINAL
CAUTION:
Wait for 90 seconds ...
