Toyota Sienna Service Manual: Installation
1. REMOVE FRONT SEAT INNER BELT ASSEMBLY
HINT:
- Refer to the instructions for reassembly of the front seat assembly (for flat type).
- Refer to the instructions for reassembly of the front seat assembly (for manual seat).
- Refer to the instructions for reassembly of the front seat assembly (for power seat).
- Install the front seat inner belt assembly with the
nut.
Torque: 42 N*m (430 kgf*cm, 31 ft.*lbf)
Inspection
1. INSPECT FRONT SEAT INNER BELT ASSEMBLY RH
Release the seat belt (Buckle switch is ON).
Check the resistance between the terminals.
Standard
If the result is not as speci ...
Front seat outer belt assembly
COMPONENTS
...
Other materials:
Check mode procedure
HINT:
Intelligent tester only:
Compared to normal mode, check mode is more sensitive to
malfunctions. Therefore, check mode can detect the
malfunctions that cannot be detected by normal mode.
NOTICE:All the stored DTCs and freeze frame data are
erased if:
1) the ECM is changed fro ...
Disposal
HINT:
Use the same procedures for the RH side and LH side.
The procedures listed below are for the LH side.
When scrapping a vehicle equipped with the SRS or
disposing of the curtain shield airbag assembly, be sure to
deploy the airbag first in accordance with the procedure
described b ...
Only Back Door cannot be Opened
DESCRIPTION
With power back door: The signal for manual locking/unlocking operation of
the driver/passenger side
door and the signal for locking/unlocking operation interlocked with the driver
side door key cylinder are
sent to the back door ECU from the body ECU using the MPX line. In respon ...
