Toyota Sienna Service Manual: Front seat side airbag assembly

Disposal

HINT: Use the same procedures for the RH side and LH side. The procedures listed below are for the LH side. When scrapping a vehicle equipped with the SRS or disposing of the curtain shield ...

On-vehicle inspection

1. FRONT SEAT SIDE AIRBAG ASSEMBLY (VEHICLE NOT INVOLVED IN COLLISION)  Perform a diagnostic system check.  With the front seat side airbag assembly installed on the vehicle, per ...

Other materials:

Installation
1. INSTALL CENTER REAR SEAT LAP TYPE BELT ASSEMBLY (for 8-Passenger) HINT: Refer to the instructions for reassembly of the rear No. 1 seat assembly (for center seat).  Install the center rear seat lap type belt assembly with the bolt. Torque: 42 N*m (430 kgf*cm, 31 ft.*lbf) 2. IN ...

Short to GND in Curtain Shield Squib RH Circuit
DTC B1162/81 Short to GND in Curtain Shield Squib RH Circuit DESCRIPTION The curtain shield squib RH circuit consists of the center airbag sensor assembly and the curtain shield airbag assembly RH. The circuit instructs the SRS to deploy when deployment conditions are met. DTC B1162/81 is ...

Safety Connect LED light Indicators
When the engine switch is turned to the “ON” position (vehicles without a smart key system) or IGNITION ON mode (vehicles with a smart key system), the red indicator light comes on for 2 seconds then turns off. Afterward, the green indicator light comes on, indicating that the service is act ...