Toyota Sienna Service Manual: High Temperature
DTC 44-47 High Temperature
DESCRIPTION
|
DTC No. |
DTC Detecting Condition |
Trouble Area |
|
44-47 |
Sensor detects that DVD unit temperature is high.
(Over 80C) |
Television display assembly |
INSPECTION PROCEDURE
HINT: After the inspection is completed, clear the DTCs
1 CHECK TELEVISION DISPLAY ASSEMBLY
- Park the vehicle in a cool place.
- Check that the temperature of the television display
assembly becomes sufficiently low, and start the engine.
Check that the malfunction disappears.
OK: Malfunction disappears.
END
Scratched / Reversed Disc
DTC 44-46 Scratched / Reversed Disc
DESCRIPTION
DTC No.
DTC Detecting Condition
Trouble Area
44-46
Scratches or dirt is found on DVD surface or DVD is set
...
DSP Error
DTC 44-78 DSP Error
DESCRIPTION
DTC No.
DTC Detecting Condition
Trouble Area
44-78
An error occurs during the decode process (MP3/
WMA).
-
IN ...
Other materials:
Problem symptoms table
HINT:
Use the table below to help determine the cause of the
problem symptoms. The potential causes of the symptoms
are listed in order of probability in the ''Suspected Area''
column of the table. Check each symptom by checking the
suspected areas in the order they are listed. Rep ...
Disassembly
1. REMOVE FRONT DISC BRAKE BUSH DUST BOOT
(a) Using soft jaws on the vise, hold the front disc brake
cylinder mounting LH in the vise through aluminum
plates.
(b) Using a screwdriver and hammer, remove the 2
front disc brake bush dust boots from the front disc
brake cylinder mounting LH. ...
Installation
1. INSTALL REAR AXLE HUB & BEARING ASSEMBLY LH
(a) Install the hub & bearing assembly LH with the 4
bolts.
Torque: 56 N*m (571 kgf*cm, 41 ft.*lbf)
2. INSPECT BEARING BACKLASH (See page AH-19)
3. INSPECT AXLE HUB DEVIATION (See page AH-19)
4. INSTALL REAR DRIVE SHAFT ASSEMBLY LH (Se ...
