Toyota Sienna Service Manual: Front washer motor
ON-VEHICLE INSPECTION
1. INSPECT FRONT WASHER MOTOR
- Operation Check
- Pour the water into the washer jar with the windshield washer motor and pump installed to the washer jar assembly.
- Connect the battery (+) to the terminal 1 of the
windshield washer motor and pump assembly,
the battery (-) to the terminal 2 of the
windshield washer motor and pomp assembly.
Check that the water comes out from the washer jar.
Wiper switch
COMPONENTS
REMOVAL
1. REMOVE STEERING COLUMN COVER
2. REMOVE WINDSHIELD WIPER SWITCH ASSEMBLY
Disconnect the connector.
Using a screwdriver, disengage the claw and pull
...
Rear washer motor
ON-VEHICLE INSPECTION
1. INSPECT REAR WASHER MOTOR
Pour the water into the washer jar with the rear
washer motor assembly installed to the washer jar
assembly.
Connect the b ...
Other materials:
Changing shift ranges in S mode
To enter S mode, shift the shift lever to S. Shift ranges can be selected
by operating the shift lever, allowing you to drive in the shift range of
your choosing. The shift range can be selected by the shift lever.
Upshifting
Downshifting
The selected shift range, from 1 to
6, will b ...
Driving in vehicle-to-vehicle distance control mode
This mode employs a radar sensor to detect the presence of vehicles
up to approximately 400 ft. (120 m) ahead, determines the current
vehicle-to-vehicle following distance, and operates to maintain a suitable
following distance from the vehicle ahead.
Note that vehicle-to-vehicle distance will ...
ECM / PCM Processor
DTC P0606 ECM / PCM Processor
DESCRIPTION
The ECM continuously monitors its internal processors (CPUs), A/F sensor
transistors and heated oxygen
sensor (HO2S) transistors. This self-check ensures that the ECM is functioning
properly. These are
diagnosed by internal "mirroring" of t ...
