Toyota Sienna Service Manual: Wiper and washer

BRK relay

ON-VEHICLE INSPECTION 1. BRK RELAY  Inspect relay resistance. Resistance ...

Wiper and washer system

PRECAUTION 1. PRECAUTION OF WASHER NOZZLE ADJUSTMENT  Do not clean or adjust the washer nozzle with a safety pin, etc. because;  the washer nozzle tip is made of resin and could ...

Other materials:

Installation
1. INSTALL LOWER BALL JOINT ASSEMBLY FRONT LH (a) Install the lower ball joint assembly front LH and tighten the nut. Torque: 123 N*m (1,250 kgf*cm, 91 ft.*lbf) (b) Install a new cotter pin. NOTICE: If the holes for the cotter pin are not aligned, tighten the nut further up to 60°. 2. INS ...

Terminals of ECU
1. Instrument Panel Junction Block Assembly ...

Slip Indicator Light does not Come ON
DESCRIPTION The skid control ECU is connected to the combination meter via CAN and multiplex communications. The SLIP indicator blinks during VSC and/or TRAC operation. When the system fails, the SLIP indicator comes on to warn the driver. WIRING DIAGRAM Refer to Slip Indicator Light Rema ...