Toyota Sienna Service Manual: Installation
1. INSTALL REAR SEAT 3 POINT TYPE BELT ASSEMBLY (for 8-Passenger)
HINT: Refer to the instructions for reassembly of the rear No. 1 seat assembly (for center seat).
- Install the rear seat 3 point type belt assembly with
the bolt.
Torque: 42 N*m (430 kgf*cm, 31 ft.*lbf)
2. INSTALL REAR SEAT 3 POINT TYPE BELT ASSEMBLY (for 7-Passenger)
HINT: Refer to the instructions for reassembly of the rear No. 1 seat assembly (for captain seat type).
- Install the rear seat 3 point type belt assembly with
the bolt.
Torque: 42 N*m (430 kgf*cm, 31 ft.*lbf)
3. INSTALL REAR SEAT 3 POINT TYPE BELT ASSEMBLY
HINT:
- Refer to the instructions for reassembly of the rear No. 2 seat assembly (for power seat type RH side).
- Refer to the instructions for reassembly of the rear No. 2 seat assembly (for manual seat type RH side).
- Install the rear seat 3 point type belt assembly with
the bolt.
Torque: 42 N*m (430 kgf*cm, 31 ft.*lbf)
4. INSTALL REAR SEAT INNER BELT ASSEMBLY
HINT:
- Refer to the instructions for reassembly of the rear No. 2 seat assembly (for power seat type LH side).
- Refer to the instructions for reassembly of the rear No. 2 seat assembly (for manual seat type LH side).
- Install the rear seat inner belt assembly with the
bolt.
Torque: 42 N*m (430 kgf*cm, 31 ft.*lbf)
Removal
1. REMOVE REAR SEAT 3 POINT TYPE BELT
ASSEMBLY (for 8-Passenger)
HINT:
Refer to the instructions for disassembly of the rear No. 1 seat assembly (for
center seat).
Remove the bolt and r ...
Rear seat outer belt assembly
COMPONENTS
...
Other materials:
Installation
1. INSTALL REAR NO. 1 SEAT ASSEMBLY LH
Place the seat in the cabin.
NOTICE:
Be careful not to damage the body.
Install the seat.
7-Passenger RH:
Install the seat belt anchor plate with the bolt.
Torque: 42 N*m (428 kgf*cm, 31 ft.*lbf)
Install the headrest. ...
Pressure Control Solenoid "B" Performance (Shift
Solenoid Valve SL2)
SYSTEM DESCRIPTION
The ECM uses signals from the vehicle speed sensor to detect the actual gear
position (1st, 2nd, 3rd, 4th
or 5th gear).
Then the ECM compares the actual gear with the shift schedule in the ECM memory
to detect mechanical
problems of the shift solenoid valves, valve b ...
How to proceed with troubleshooting
The intelligent tester can be used at steps 3, 7, 10, and 13.
1 VEHICLE BROUGHT TO WORKSHOP
2 CUSTOMER PROBLEM ANALYSIS
(a) Interview the customer to confirm the trouble.
3 DTC CHECK/CLEAR AND FREEZE FRAME DATA
4 PROBLEM SYMPTOM CONFIRMATION
5 PROBLEM SYMPTOM SIMULATION
6 SYMPTOM SI ...
