Toyota Sienna Service Manual: Removal
1. REMOVE REAR SEAT 3 POINT TYPE BELT ASSEMBLY (for 8-Passenger)
HINT: Refer to the instructions for disassembly of the rear No. 1 seat assembly (for center seat).
- Remove the bolt and rear seat 3 point type belt assembly.
2. REMOVE REAR SEAT 3 POINT TYPE BELT ASSEMBLY (for 7-Passenger)
HINT: Refer to the instructions for disassembly of the rear No. 1 seat assembly (for captain seat type).
- Remove the bolt and rear seat 3 point type belt assembly.
3. REMOVE REAR SEAT 3 POINT TYPE BELT ASSEMBLY
HINT:
- Refer to the instructions for disassembly of the rear No. 2 seat assembly (for power seat type RH side).
- Refer to the instructions for disassembly of the rear No. 2 seat assembly (for manual seat type RH side).
- Remove the bolt and rear seat 3 point type belt assembly.
4. REMOVE REAR SEAT INNER BELT ASSEMBLY HINT:
- Refer to the instructions for disassembly of the rear No. 2 seat assembly (for power seat type LH side).
- Refer to the instructions for disassembly of the rear No. 2 seat assembly (for manual seat type LH side).
- Remove the bolt and rear seat inner belt assembly.
Rear seat inner belt assembly
COMPONENTS
...
Installation
1. INSTALL REAR SEAT 3 POINT TYPE BELT
ASSEMBLY (for 8-Passenger)
HINT: Refer to the instructions for reassembly of the rear
No. 1 seat assembly (for center seat).
Install the rear seat ...
Other materials:
When servicing full-time 4wd vehicles
The full-time 4WD SIENNA is equipped with the open
center differential system.
If incorrect preparations or test procedures are used, the
test will not only be unsuccessful, but may be dangerous
as well.
Therefore, before beginning any such servicing or test,
be sure to check the following ...
System description
1. GENERAL
In conjunction with impact absorbing structure for a
frontal collision, the SRS (Supplemental Restraint
System) driver airbag and front passenger airbag
were designed to supplement seat belts in the event
of a frontal collision in order to help reduce shock to
the head and c ...
Terminals of ECM
1. SFI SYSTEM
HINT:
The standard normal voltage between each pair of the
ECM terminals is shown in the table below. The
appropriate conditions for checking each pair of the
terminals are also indicated.
The check results should be compared with the standard
normal voltage for that pair of ...
