Toyota Sienna Service Manual: Rear seat inner belt assembly

Disposal

1. DISPOSE OF FRONT SEAT OUTER BELT ASSEMBLY (WHEN INSTALLED IN VEHICLE) NOTICE:  Never dispose of a front seat outer belt assembly with an deactivated pretensioner.  The seat belt ...

Removal

1. REMOVE REAR SEAT 3 POINT TYPE BELT ASSEMBLY (for 8-Passenger) HINT: Refer to the instructions for disassembly of the rear No. 1 seat assembly (for center seat).  Remove the bolt and r ...

Other materials:

Side Airbag Sensor Assembly RH Circuit Malfunction
DTC B1140/32 Side Airbag Sensor Assembly RH Circuit Malfunction DESCRIPTION The side airbag sensor RH circuit consists of the center airbag sensor assembly and side airbag sensor RH. If the center airbag sensor assembly receives signals from the side airbag sensor RH, it judges whether or ...

Reassembly
1. INSTALL REAR DISC (a) Aligning the matchmarks, install the rear disc. HINT: Select the installation position where the disc has the minimum runout. 2. INSPECT DISC RUNOUT (a) Temporarily fasten the disc with the hub nuts. Torque: 103 N*m (1,050 kgf*cm, 76 ft.*lbf) (b) Using a di ...

Disassembly
1. SEPARATE REAR DRIVE SHAFT INBOARD JOINT BOOT CLAMP (a) Using a screwdriver, remove the 2 rear drive shaft inboard joint boot clamps as shown in the illustration. 2. SEPARATE REAR DRIVE SHAFT INBOARD JOINT BOOT (a) Separate the rear drive shaft inboard joint boot from the inboard joint ...