Toyota Sienna Service Manual: Installation
1. INSTALL CENTER REAR SEAT LAP TYPE BELT ASSEMBLY (for 8-Passenger)
HINT: Refer to the instructions for reassembly of the rear No. 1 seat assembly (for center seat).
- Install the center rear seat lap type belt assembly
with the bolt.
Torque: 42 N*m (430 kgf*cm, 31 ft.*lbf)
2. INSTALL CENTER REAR NO. 2 SEAT LAP BELT ASSEMBLY WITH INNER
HINT:
- Refer to the instructions for reassembly of the rear No. 2 seat assembly (for power seat type LH side).
- Refer to the instructions for reassembly of the rear No. 2 seat assembly (for manual seat type LH side).
- Install the center rear No. 2 seat lap belt assembly
with inner with the bolt.
Torque: 42 N*m (430 kgf*cm, 31 ft.*lbf)
3. INSTALL REAR NO. 2 SEAT BELT ASSEMBLY INNER
HINT:
- Refer to the instructions for reassembly of the rear No. 2 seat assembly (for power seat type LH side).
- Refer to the instructions for reassembly of the rear No. 2 seat assembly (for manual seat type LH side).
- Install the rear No. 2 seat belt assembly inner with
the bolt.
Torque: 42 N*m (430 kgf*cm, 31 ft.*lbf)
Removal
1. REMOVE CENTER REAR SEAT LAP TYPE BELT
ASSEMBLY (for 8-Passenger)
HINT:
Refer to the instructions for disassembly of the rear No. 1
seat assembly (for center seat).
Remove the bolt and ...
Rear center seat outer belt assembly
COMPONENTS
...
Other materials:
Front Clearance Sonar Sensor RH Circuit
DESCRIPTION
An ultrasonic sensor consists of a sensor portion that transmits and receives
ultrasonic waves and a preamplifier
that amplifies them. The ultrasonic sensor outputs the ultrasonic waves and
sends the reveiced
signals to the clearance warning ECU.
WIRING DIAGRAM
INSPECTION PR ...
On-vehicle inspection
1. INSPECT REAR AXLE HUB BEARING BACKLASH
(a) Using a dial gauge, check for backlash near the
center of the axle hub.
Maximum:
0.05 mm (0.0020 in.)
If backlash exceeds the maximum, replace the axle
hub assembly.
NOTICE:
Ensure that the dial gauge is set at right angles
to the measuremen ...
Operation check
1. DOOR LOCK FAIL-SAFE
When a malfunction in the door control switch
(manual switch, interlocked with key operation) has
been detected, door lock/unlock operation becomes
disabled.
2. CHECK ELECTRICAL DOOR LOCK OPERATION
Check the basic function.
Check that a ...
