Toyota Sienna Service Manual: Removal
1. REMOVE CENTER REAR SEAT LAP TYPE BELT ASSEMBLY (for 8-Passenger)
HINT: Refer to the instructions for disassembly of the rear No. 1 seat assembly (for center seat).
- Remove the bolt and center seat lap type belt assembly.
2. REMOVE CENTER REAR NO. 2 SEAT LAP BELT ASSEMBLY WITH INNER
HINT:
- Refer to the instructions for disassembly of the rear No. 2 seat assembly (for power seat type LH side).
- Refer to the instructions for disassembly of the rear No. 2 seat assembly (for manual seat type LH side).
- Remove the bolt and center rear No. 2 seat lap belt assembly with inner.
3. REMOVE REAR NO. 2 SEAT BELT ASSEMBLY INNER
HINT:
- Refer to the instructions for disassembly of the rear No. 2 seat assembly (for power seat type LH side).
- Refer to the instructions for disassembly of the rear No. 2 seat assembly (for manual seat type LH side).
- Remove the bolt and rear No. 2 seat belt assembly inner.
Rear center seat inner belt assembly
COMPONENTS
...
Installation
1. INSTALL CENTER REAR SEAT LAP TYPE BELT
ASSEMBLY (for 8-Passenger)
HINT:
Refer to the instructions for reassembly of the rear No. 1
seat assembly (for center seat).
Install the center ...
Other materials:
Camshaft Position "B" - Timing Over
HINT:
If DTC P0014, P0015, P0024 or P0025 is present, check the VVT (Variable Valve
Timing) system.
DESCRIPTION
Refer to DTC P0013 (See page ES-87).
MONITOR DESCRIPTION
DTC P0014 and P0024
The ECM compares current valve timing with target valve timing, while the
engine is running a ...
Radio Receiver Power Source Circuit
DESCRIPTION
This circuit provides power to the radio receiver.
WIRING DIAGRAM
INSPECTION PROCEDURE
1 INSPECT RADIO RECEIVER ASSEMBLY
Disconnect the radio receiver connector.
Measure the resistance according to the value in the
table below.
Standard resistance
Measure t ...
Disassembly
1. REMOVE MAGNETIC CLUTCH ASSEMBLY
(a) Place the compressor and magnetic clutch in a vise.
(b) Using locking pliers, hold the magnetic clutch hub.
(c) Remove the bolt, magnetic clutch hub, and
magnetic clutch washers.
HINT:
There is no set number of magnetic clutch washers
because the ...
