Toyota Sienna Service Manual: Installation
1. INSTALL REAR NO. 2 SEAT ASSEMBLY RH
- Place the rear No. 2 seat assembly RH in the cabin.
NOTICE: Be careful not to damage the body.
- Install the seat with the bolt.
Torque: 29 N*m (296 kgf*cm, 21 ft.*lbf)
- Install the locus cable RH with the bolt.
Torque: 29 N*m (296 kgf*cm, 21 ft.*lbf)
- Install the rear seat headrest assembly RH.
HINT: Check that the seat leg locks.
2. INSTALL REAR SEAT LEG SIDE GARNISH SUBASSEMBLY RH
- Install the rear seat leg side garnish sub-assembly RH.
Reassembly
1. INSTALL REAR SEAT STAY SUB-ASSEMBLY
Install the seat stay sub-assembly with the nut.
Torque: 5.5 N*m (56 kgf*cm, 49 in.*lbf)
2. INSTALL NO. 2 SEAT CUSHION SPRING ASSEMBLY
RH
3. INS ...
Rear no. 2 Seat assembly (for Power Seat Type LH Side)
COMPONENTS
...
Other materials:
Disassembly
1. REMOVE REAR DIFFERENTIAL CARRIER COVER
(a) Remove the 8 bolts from the carrier cover.
(b) Using a brass bar and a hammer, separate the
carrier cover from rear differential carrier assembly.
(c) Remove the breather plug from the rear differential
carrier cover.
(d) Remove the bol ...
Terminals of ECU
1. CHECK POWER BACK DOOR ECU
Disconnect the P13 and P14 ECU connectors, and
check the voltage and resistance of each terminal of
the wire harness side connectors
If the result is not as specified, there may be a
malfunction on the wire harness side.
Reconnect the ECU co ...
Front door lock
INSPECTION
1. INSPECT FRONT DOOR W/ MOTOR LOCK ASSEMBLY LH
Apply battery voltage to the door lock and check
operation of the motor.
OK
HINT:
If the result is not as specified, replace the door lock
assembly.
Measure the resistance according to the value(s) in
the table ...
