Toyota Sienna Service Manual: Seat
- Front power seat control system
- Precaution
- System description
- How to proceed with troubleshooting
- Problem symptoms table
- Terminals of ECU
- Diagnosis system
- Data list / active test
- On-vehicle inspection
- Seat heater system
- Front seat assembly (for Flat Type)
- Front seat assembly (for Manual Seat)
- Front seat assembly (for Power Seat)
- Rear no. 1 Seat assembly (for Captain Seat Type)
- Rear no. 1 Seat assembly (for Center Seat)
- Rear no. 2 Seat assembly (for Manual Seat Type LH Side)
- Rear no. 2 Seat assembly (for Manual Seat Type RH Side)
- Rear no. 2 Seat assembly (for Power Seat Type LH Side)
- Rear no. 2 Seat assembly (for Power Seat Type RH Side)
- Rear no. 2 Seat assembly (w/ Power Stowing Function)
- Precaution
- System description
- How to proceed with troubleshooting
- Initialization
- Problem symptoms table
- Terminals of ECU
- Diagnosis system
- On-vehicle inspection
- Seat memory switch
- Power seat switch
- Front seat frame with adjuster
- Front power seat lumbar switch
- Lumbar support adjuster assembly
Installation
1. INSTALL 3 POINT TYPE NO. 2 REAR SEAT BELT ASSEMBLY
Check the degree of tilt when the belt begins to lock
the ELR.
Check that the belt does not lock within 15 of
tilt i ...
Other materials:
Installation
1. INSTALL CENTER AIRBAG SENSOR ASSEMBLY
Check that the ignition switch is off.
Check that the battery negative (-) terminal is
disconnected.
CAUTION:
After disconnecting the negative battery
terminal, wait for at least 90 seconds before
starting the operation.
Temporar ...
Check mode procedure
1. CHECK MODE (SIGNAL CHECK): DTC CHECK
Connect the intelligent tester to the DLC3.
) Turn the ignition switch to the ON position.
) Select the "SIGNAL CHECK", and proceed
checking using the intelligent tester.
NOTICE:
Select the "SIGNAL CHECK" from the &q ...
Open in Rear Curtain Shield Squib RH Circuit
DTC B1631/84 Open in Rear Curtain Shield Squib RH Circuit
DESCRIPTION
The rear curtain shield squib RH circuit consists of the center airbag sensor
assembly and the curtain
shield airbag assembly RH.
The circuit instructs the SRS to deploy when deployment conditions are met.
DTC B1631/84 ...
