Toyota Sienna Service Manual: Installation
1. INSTALL FRONT DOOR WINDOW FRAME MOULDING
- Remove the tape from the front door window frame moulding.
- Clean the contact surface of the vehicle body with white gasoline.
- Clean the outer circumference of the front door window frame moulding with white gasoline.
- Apply new double-sided tape to the front door window frame moulding, as shown in the illustration.
Dimensions:
- Using a heat light, heat the vehicle body and front door window frame moulding.
Heating temperature:
NOTICE: Do not heat the body and front door window frame moulding excessively.
- Remove the peeling paper from the face of the front
door window frame moulding face.
HINT: Be careful that dirt or foreign objects do not stick to the adhesive part when removing the peeling paper.
- Engage the 2 claws and install the front door window frame moulding with the screw.
NOTICE: Do not apply excessive force onto the front door window frame moulding, but steady pressure with your thumbs.
Removal
1. REMOVE FRONT DOOR WINDOW FRAME MOULDING
Remove the screw.
Using a heat light, heat the front door window frame
moulding between 40 to 60 C (104 to 140 F).
NOTICE:
Do not heat the fr ...
Rear door window frame moulding
COMPONENTS
...
Other materials:
Ambient temperature sensor
ON-VEHICLE INSPECTION
1. INSPECT A/C AMBIENT TEMPERATURE SENSOR
(a) Remove the A/C ambient temperature sensor.
(b) Disconnect the connector from A/C ambient
temperature sensor.
(c) Measure the resistance according to the value(s) in
the table below.
Standard resistance
NOTICE:
E ...
Wireless remote control
Vehicles without a smart key system (type A)
Locks all doors
Unlocks all doors
Sounds the alarm
Vehicles without a smart key system (type B)
Locks all doors
Unlocks all doors
Opens and closes the left side power sliding door
Opens and closes the right sid ...
Inspection
1. INSPECT BRAKE CYLINDER AND PISTON
(a) Check the brake cylinder bore and front disc brake
piston for rust or scoring.
2. INSPECT PAD LINING THICKNESS
(a) Using a ruler, measure the pad lining thickness.
Standard thickness:
12.0 mm (0.472 in.)
Minimum thickness:
1.0 mm (0.039 in.)
3. ...
