Toyota Sienna Service Manual: Rear door window frame moulding

Installation

1. INSTALL FRONT DOOR WINDOW FRAME MOULDING Remove the tape from the front door window frame moulding. Clean the contact surface of the vehicle body with white gasoline. Clean the oute ...

Removal

1. REMOVE REAR DOOR WINDOW FRAME MOULDING Remove the screw. Using a heat light, heat the rear door window frame moulding between 40 to 60 C (104 to 140 F). NOTICE: Do not heat the rear ...

Other materials:

Customize parameters
1. Seat Belt Buzzer ON/OFF Setting The seat belt buzzer ON/OFF setting, which is a setting of the buzzer function of the combination meter, can disable the driver side seat belt buzzer and front passenger side seat belt buzzer. NOTICE: These buzzers should be on for safe driving. Perform ...

Mass air flow meter
COMPONENTS ON-VEHICLE INSPECTION 1. INSPECT MASS AIR FLOW METER NOTICE: Perform the mass air flow (MAF) meter inspection by following the procedures below. Only replace the MAF meter when the MAF value in the DATA LIST (with the engine stopped) are not within th ...

Radio Receiver Communication Error
INSPECTION PROCEDURE 1 IDENTIFY THE COMPONENT SHOWN BY THE SUB-CODE Enter the diagnostic mode Press the preset switch "3" to change to "Detailed Information Mode".  Identify the component shown by the sub-code. HINT:  "190 (radio receiver) ...