Toyota Sienna Service Manual: Front door window frame moulding

Installation

1. INSTALL OUTSIDE MOULDING Using a heat light, heat the mounting surface of the vehicle body between 40 to 60 C (104 to 140 F). NOTICE: Do not heat the body excessively. Remove the tape f ...

Removal

1. REMOVE FRONT DOOR WINDOW FRAME MOULDING Remove the screw. Using a heat light, heat the front door window frame moulding between 40 to 60 C (104 to 140 F). NOTICE: Do not heat the fr ...

Other materials:

High pitched horn
COMPONENTS REMOVAL 1. REMOVE FRONT BUMPER COVER 2. REMOVE HIGH PITCHED HORN  Disconnect the connector.  Remove the bolt and horn. INSPECTION 1. INSPECT HIGH PITCHED HORN  Apply battery voltage and check operation of the horn, as shown in the table. Standard ...

GPS Mark is not Displayed
INSPECTION PROCEDURE 1 CHECK CABIN Check the cabin for any object that might interrupt radio reception on the instrument panel. If such an object exists, remove it and check if the GPS mark reappears. HINT: The GPS uses extremely faint radio waves originating from satellites. If the si ...

Installation
HINT:  Use the same procedures for the RH side and LH side.  The procedures listed below are for the LH side. 1. INSTALL SIDE AIRBAG SENSOR LH Check that the ignition switch is off.  Check that the battery negative (-) terminal is disconnected. CAUTION: Afte ...