Toyota Sienna Service Manual: Installation
1. INSTALL FRONT FENDER GARNISH
- Engage the 3 clips to install the front fender garnish.
Removal
1. REMOVE FRONT FENDER GARNISH
Using a moulding remover, disengage the 3 clips to
remove the front fender garnish
...
Back door outside garnish
COMPONENTS
...
Other materials:
Unmatched Key Code
DTC B2795 Unmatched Key Code
DESCRIPTION
This DTC is output when a key with a code that has not been registered in the
ECU is inserted into the
ignition key cylinder.
DTC No.
DTC Detection Condition
Trouble Area
B2795
Key with unregistered key code is i ...
Disassembly
1. REMOVE REAR DOOR WINDOW FRAME MOULDING
REAR LH (See page ET-31)
2. REMOVE REAR DOOR WINDOW FRAME MOULDING
SUB-ASSEMBLY LH (See page ET-32)
3. REMOVE SLIDE DOOR WINDOW GARNISH LH
Fully open the slide door window.
Remove the glass run.
Using a screwdriver, disengage the clip and rem ...
Front axle hub bolt
COMPONENTS
Replacement
HINT:
Replace the RH side using the same procedures as for the
LH side.
1. REMOVE FRONT WHEEL
2. SEPARATE FRONT DISC BRAKE CALIPER
ASSEMBLY LH (See page AH-5)
3. REMOVE FRONT DISC
4. REMOVE FRONT AXLE LH HUB BOLT
(a) Temporarily install the 2 nuts and washers ...
