Toyota Sienna 2010-2026 Owners Manual: Locking and unlocking the doors and key linked functions
Using the mechanical key in order to perform the following operations.
- Locks all the doors
- Unlocks the door(s)
Turning the key rearward unlocks the driver’s door. Turning the key once again within 3 seconds unlocks the other doors
If the electronic key does
not operate properly
(vehicles with a smart
key system)
If communication between the electronic key and vehicle is
interrupted or the electronic key cannot be used
because the battery is depleted, the smart key system and wireless
remote control cannot ...
Starting the engine
Shift the shift lever to P and apply the brakes.
Touch the Toyota emblem side
of the electronic key to the
engine switch.
An alarm will sound to indicate that
the start function canno ...
Other materials:
Vehicle Speed Signal Circuit between Radio and Navigation Assembly
and Combination Meter
DESCRIPTION
The radio and navigation assembly receives a vehicle speed signal from the
combination meter and
information about the GPS antenna, and then adjusts vehicle position.
HINT:
A voltage of 12 V or 5 V is output from each ECU and then input to
the combination meter. The sig ...
Active test
HINT:
Performing an ACTIVE TEST enables components
including the relays, VSV (Vacuum Switching Valve), and
actuators, to be operated without removing any parts.
The ACTIVE TEST can be performed with an intelligent
tester. Performing an ACTIVE TEST in the first step in
troubleshooting is one ...
Drive shaft system
PRECAUTION
1. NOTICE OF REMOVING AND INSTALLING FRONT
DRIVE SHAFT ASSEMBLY RH
(a) When removing and installing the front drive shaft
assembly RH in a 4WD vehicle, be sure to first drain
all the transaxle oil and transfer oil. If removal and
installation is carried out without draining these oi ...
