Toyota Sienna Service Manual: Mass air flow meter

Installation

1. INSTALL ACCELERATOR PEDAL ROD NOTICE:  Avoid physical shock to the accelerator pedal assembly.  Do not disassemble the accelerator pedal assembly.  Install the a ...

On-vehicle inspection

1. INSPECT MASS AIR FLOW METE NOTICE:  Perform the mass air flow (MAF) meter inspection by following the procedures below.  Only replace the MAF meter when the MAF value in th ...

Other materials:

Vanity light
ON-VEHICLE INSPECTION 1. LH VISOR ASSEMBLY  Inspect vanity light resistance.  check that the resistance exists between the terminal 1 and the terminal 2 when the light is operated. Resistance: OFF (closed): 10 kΩ or higher ON (opened): Below 1 Ω 2. RH VISOR ...

Brake Switch "B" Circuit High
DESCRIPTION The purpose of this circuit is to prevent the engine from stalling while driving in lock-up condition when brakes are suddenly applied. When the brake pedal is depressed, this switch sends a signals to the ECM. Then the ECM cancels the operation of the lock-up clutch while ...

Open in Rear Curtain Shield Squib LH Circuit
DTC B1636/88 Open in Rear Curtain Shield Squib LH Circuit DESCRIPTION The rear curtain shield squib LH circuit consists of the center airbag sensor assembly and the curtain shield airbag assembly LH. The circuit instructs the SRS to deploy when deployment conditions are met. DTC B1636/88 ...