Toyota Sienna Service Manual: Inspection
1. INSPECT MASS AIR FLOW METER
- Visually check for any foreign matter on the
platinum hot wire (heater) of the mass air flow
meter.
OK: There is no foreign matter.
If the result is not as specified, replace the mass air flow meter.
- Measure the resistance according to the value(s) in the table below.
Standard resistance
Removal
1. REMOVE MASS AIR FLOW METER
Disconnect the mass air flow meter connector.
Remove the 2 screws and mass air flow meter.
...
Installation
1. REMOVE MASS AIR FLOW METER
Install the mass air flow meter with the 2 screws.
Connect the mass air flow meter connector.
...
Other materials:
Hydraulic test
1. Perform hydraulic test
(a) Measure the line pressure.
NOTICE:
Perform the test at the normal operating ATF
(Automatic Transmission Fluid) temperature:
50 to 80°C (122 to 176°F).
The line pressure test should always be
carried out in pairs. One technician should
...
Park / Neutral Position Switch Circuit
DESCRIPTION
The clearance warning ECU receives the reverse or park position signal from
the park / neutral position
switch.
WIRING DIAGRAM
INSPECTION PROCEDURE
1 INSPECT CLEARANCE WARNING ECU
Disconnect the C9 connector from the clearance warning
ECU.
Measure the voltage ...
Removal
1. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH
2. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG
3. REMOVE FRONT DOOR ARMREST BASE PANEL
ASSEMBLY
4. REMOVE BACK FRAME PLATE
5. REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY
6. REMOVE FRONT DOOR TRIM BOARD SUBASSEMBLY
7. REMOVE OUTER RE ...
