Toyota Sienna Service Manual: Navigation antenna

Installation

1. INSTALL NO.1 NAVIGATION BRACKET  Install the No.1 navigation bracket with the 4 screws. 2. INSTALL NO.2 NAVIGATION BRACKET  Install the No.2 navigation bracket with t ...

Removal

1. BOLT, SCREW AND NUT TABLE  The bolts, the screws and the nuts, which are necessary for installation and removal of the instrument panel are shown in the illustration below with alpha ...

Other materials:

Using a flatbed truck
If you use chains or cables to tie down your vehicle, the angles shaded in black must be 45. Do not overly tighten the tie downs or the vehicle may be damaged. WARNINGObserve the following precautions. Failure to do so may result in death or serious injury. When tow ...

Reassembly
1. INSTALL MAGNETIC CLUTCH ASSEMBLY (a) Install the magnetic clutch stator while aligning the protrusion on the stator with the notch on the air compressor assembly as shown in the illustration. (b) Using a snap ring expander, install a new snap ring with the chamfered side facing up. ...

Oxygen Sensor Circuit Malfunction/ Oxygen Sensor Circuit Low Voltage/ Oxygen Sensor Circuit High Voltage
DTC P0136 Oxygen Sensor Circuit Malfunction (Bank 1 Sensor 2) DTC P0137 Oxygen Sensor Circuit Low Voltage (Bank 1 Sensor 2) DTC P0138 Oxygen Sensor Circuit High Voltage (Bank 1 Sensor 2) DTC P0156 Oxygen Sensor Circuit Malfunction (Bank 2 Sensor 2) DTC P0157 Oxygen Sensor Circuit Low Voltage ...