Toyota Sienna Service Manual: Navigation
- Navigation system
- System description
- How to proceed with troubleshooting
- Identification of noise source
- System normal condition check
- Display check mode
- Bluetooth tel check mode
- Navigation check mode
- Diagnosis display detailed description
- Problem symptoms table
- Terminals of ECU
- DTC check / clear
- Diagnostic trouble code chart
- Navigation receiver
- Navigation antenna
No. 2 Speaker with box
COMPONENTS
ON-VEHICLE INSPECTION
1. INSPECT NO.2 SPEAKER WITH BOX
HINT:
Remove interior parts so that the No.2 speaker with box
can be seen.
Check the speaker installation.
OK ...
Navigation system
PARTS LOCATION
SYSTEM DIAGRAM
...
Other materials:
Diagnostic trouble code chart
1. DTC CHECK
If a malfunction code is displayed during the DTC check ,
check the suspected area listed for that code in the table
below, and proceed to the appropriate page.
DIAGNOSTIC TROUBLE CODE CHART
DTC No.
Detection Item
Suspect Area
B1244
Light Se ...
Ignition Coil "A" Primary
HINT:
These DTCs indicate malfunctions relating to the primary circuit.
If DTC P0351 is set, check the No. 1 ignition coil with igniter circuit.
If DTC P0352 is set, check the No. 2 ignition coil with igniter circuit.
If DTC P0353 is set, check the No. 3 ignition coil with igniter circ ...
Reassembly
1. INSTALL NO. 1 SEAT CUSHION FRAME SUBASSEMBLY
LH
Install the seat cushion frame with the bolt.
Torque: Except 7-Passenger RH, M8 bolt
20.6 N*m (210 kgf*cm, 15 ft.*lbf)
M10 bolt
41 N*m (418 kgf*cm, 30 ft.*lbf)
2. INSTALL RECLINING CONTROL LINK SUBASSEMBLY
LH
Install ...
