Toyota RAV4 manuals

Toyota Sienna Service Manual: Parts location

Parts location

Parts location

Power door lock control system
...

How to proceed with troubleshooting
HINT:  Use these procedures to troubleshoot the power door lock control system.  The intelligent tester should be used in steps 3 and 5. 1 VEHICLE BROUGHT TO WORKSHOP 2 CUSTOMER ...

Other materials:

Installation
HINT: Install the RH side by same procedure as the LH side. 1. INSTALL REAR SPEED SENSOR (a) Install the speed sensor rear LH with the bolt. Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf) NOTICE: Keep the tip of the speed sensor rear LH clean. (b) Install the sensor harness clamps with the b ...

Terminals of ECM
1. SFI SYSTEM HINT: The standard normal voltage between each pair of the ECM terminals is shown in the table below. The appropriate conditions for checking each pair of the terminals are also indicated. The check results should be compared with the standard normal voltage for that pair of ...

Diagnosis system
1. CHECK DLC3 The vehicle's ECU uses ISO 15765-4 for communication protocol. The terminal arrangement of the DLC3 complies with SAE J1962 and matches the ISO 15765-4 format. NOTICE: *: Before measuring the resistance, leave the vehicle as is for at least 1 minute and do not ope ...

В© 2011-2023 Copyright www.tsienna.net