Toyota Sienna Service Manual: Power door lock control system
- Parts location
- How to proceed with troubleshooting
- Operation check
- Customize parameters
- Problem symptoms table
- Terminals of ECU
- Diagnosis system
- Data list / active test
Door lock
...
Parts location
...
Other materials:
Short to GND in Curtain Shield Squib RH Circuit
DTC B1162/81 Short to GND in Curtain Shield Squib RH Circuit
DESCRIPTION
The curtain shield squib RH circuit consists of the center airbag sensor
assembly and the curtain shield
airbag assembly RH.
The circuit instructs the SRS to deploy when deployment conditions are met.
DTC B1162/81 is ...
Terminals of ECU
1. CHECK OUTER MIRROR CONTROL ECU LH
Disconnect the O9 and O10 connectors.
Measure the voltage and resistance according to
the value(s) in the table below.
Voltage
Resistance
If the result is not as specified, there may be a
malfunction on the wire harness side.
Recon ...
Installation
HINT:
Install the RH side by the same procedures with LH side.
1. INSTALL FRONT SPEED SENSOR LH
(a) Install the speed sensor front LH with the bolt.
Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf)
NOTICE:
Keep the tip of the front speed sensor LH.
(b) Install the sensor harness clamps with th ...
