Toyota Sienna Service Manual: Door lock
- Power door lock control system
- Parts location
- How to proceed with troubleshooting
- Operation check
- Customize parameters
- Problem symptoms table
- Terminals of ECU
- Diagnosis system
- Data list / active test
- Wireless door lock control system
- Parts location
- How to proceed with troubleshooting
- Operation check
- Registration
- Customize parameters
- Problem symptoms table
- Terminals of ECU
- Diagnosis system
- DTC check / clear
- Data list / active test
- Diagnostic trouble code chart
- Key reminder warning system
- How to proceed with troubleshooting
- Operation check
- Terminals of ECU
- Diagnosis system
- Data list / active test
- Unlock Warning Switch Circuit
- Transmitter battery
- Door control transmitter
- Door control switch
- Unlock warning switch
- Front door lock
- Rear door lock
- Back door lock
Washer nozzle
ADJUSTMENT
1. REMOVE WASHER NOZZLE
With the engine running, check that the point where
the washer fluid hits the rear window is within the
range indicated by the hatched line.
...
Other materials:
Engine rear oil seal
Components
Removal
1. REMOVE AUTOMATIC TRANSAXLE ASSEMBLY (for
2WD)
HINT:
See page AX-163.
2. REMOVE AUTOMATIC TRANSAXLE ASSEMBLY (for
4WD)
HINT:
See page AX-167.
3. REMOVE DRIVE PLATE AND RING GEAR SUBASSEMBLY
(a) Using SST, hold the crankshaft.
SST 09213-70011 (09213-70020), ...
High Temperature
DTC 63-47 High Temperature
DESCRIPTION
DTC No.
DTC Detection Condition
Trouble Area
63-47
Sensor detects that CD unit temperature is high (Over
80C).
Radio and navigation assembly
INSPECTION PROCEDURE
HINT:
After the inspection is completed, c ...
On-vehicle inspection
1. INSPECT FRONT AXLE HUB BEARING BACKLASH
(a) Using a dial gauge, check for backlash near the
center of the axle hub.
Maximum:
0.05 mm (0.0020 in.)
If backlash exceeds the maximum, replace the
bearing.
NOTICE:
Ensure that the dial gauge is set at right angles
to the measurement surface ...
